Search

1/2" End Cap

$2.60
1/2-in Poly End Fitting with 3/4-in hose-thread end cap and locking collar (QTY 1)
Made in the USA
+ -

Use this end cap fitting to end the water supply at the end of the 1/2-in poly tubing

Typically used to close-off the water supply at the end of the 1/2-in poly tubing lines and has a removable threaded cap to flush the line or to open the end to winterize

To attach the 1/2-in poly tubing first push the collar back to expose the barb with a built in O-ring

Push and wiggle the 1/2-in poly onto the fitting and under the collar until snug

While holding the tubing with 1 hand turn the ears of the collar in a left counter-clockwise motion to tightened and lock onto the 1/2-in poly tubing

Unthread the end cap to open the end of the line to drain or flush the water out

This fitting can be uninstalled easily by unthreading the collar in a clockwise motion then by pulling off the 1/2-in poly

If you find it difficult to get the 1/2-in poly tubing onto the fitting, use a little olive oil or vegetable oil by wiping it on the inside of the wall of 1/2-in poly then push in the fittings

 

Customers who bought this item also purchased

Green Stake Assemb. (MLS-211)

Green Landscape Stake Assembly with On/Off Valve and 10 GPH Flow-Controller. Each stake sold separately / Mister NOT included.
$3.89

Black Stake Assemb (MLS-BLA)

Black Landscape Stake Assembly with On/Off Valve and 10 GPH Flow-Controller. Each stake sold separately / Mister NOT included.
$3.89

1/2-in Poly Elbow Fitting (MLF-35)

1/2-in Poly Elbow Fitting with locking collars (Qty 1)
$2.09

1/2" Poly Tee Fitting (MLF-34)

1/2-in Poly Tee Fitting with Locking Collars (QTY 1)
$2.22