1/2" Pvc Tee to 1/2" Poly-NO Coup

This Retrofit Tee Adapter has a 1/2" male pipe thread inlet and a 1/2" poly barb outlet with 2 barbed outlets with Locking Collar. This Tee Adapter has no Coupler and can be attached to a 1/2" female pvc pipe thread (fpt)
Made in the USA
+ -


Use this fitting when attaching our 1/2-in poly tubing to run a water supply to micro or drip irrigation in opposite directions off an existing underground irrigation system

This fitting will attach to a PVC riser with a 1/2-in FNPT

Once this fitting is attached to the PVC riser then next attach the 1/2-in poly tubing by first pushing back the locking collar to expose the barb with a built in O-ring

Next push and wiggle the 1/2-in poly onto the fitting and under the collar until snug

Now while holding the tubing with 1 hand turn the ears of the collar in a left counter clockwise motion to tightened and lock onto the 1/2-in poly tubing

This fitting can be uninstalled easily by unthreading the collar in a clockwise motion then by pulling off the 1/2-in poly

If you find it difficult to get the 1/2-in poly tubing onto the fitting, use a little olive oil or vegetable oil by wiping it on the inside of the wall of 1/2-in poly then push in the fittings.


Customers who bought this item also purchased

Green Stake Assemb. (MLS-211)

Green Landscape Stake Assembly with On/Off Valve and 10 GPH Flow-Controller. Each stake sold separately / Mister NOT included.

1/2" pvc to 1/2" poly (MLA-P2P)

1/2-in PVC to 1/2-in Poly Tubing Adapter with Locking Collar. (Qty 1)

1/2" PVC Elb to 1/2 poly (MLA-P2PELB)

This Retrofit Elbow Adapter has a 1/2-in male pipe thread inlet, and a 1/2-in poly barb outlet with Locking Collar. (Qty 1)

1/2" End Crimper (MLA-50)

1/2-in Poly End Crimpers. (Qty 3)