These 3-in-1 Swap Top Mister micro-sprays give you 3 choices of spray patterns including a 360° flat fan spray, a narrow center strip, and a 90° half circle spray pattern.
This 3-in-1 Swap Top Mister micro-spray is ideal for watering small areas, atriums, shrubs, small trees, plants, flowers, shrubs, and trees along walkways, fences, driveways, and the perimeter of a house
Easy to interchange the spray patterns by sliding off the swap top reversing it then sliding it back onto the G-shaped micro-spray mister
The Red G shaped micro spray is ideal for roses as the 360° x 14 stream down spray keeps water off foliage and petals and waters up to a 4-ft diameter.
Slide the yellow swap top onto the red G shaped micro spray and you will receive on on one side, a 90° fan spray that is ideal for use in corners and tight areas and waters up to a 4 to 5-ft radius. If you reverse the swap top, you will receive a narrow center strip on one side that waters a spray width of 1-3-ft and is ideal for long narrow areas of landscaping.
When installed on top of our mister-riser assemblies (MLS-231) or any of our micro-stake assemblies (MLS-211, MLS-TAN, or MLS-BLA) this micro-spray will be flow-controlled to only use 10 GPH
(4 Misters Per Bag)
(Made in the USA)
RECOMMENDATIONS & LIMITATIONS
When installing any irrigation system, it is important to be aware of manufacturer recommendations and potential system limitations. Please be aware of the following:
The timer (MLWT-1ZONE, MLWT-TWOZONE or MLWT-EGG) must always be the first thing attached to the faucet, then the pressure regulator (MLA-58), filter (MLFF-41), and then a poly faucet hose fitting (MLF-33)
When winterizing your system, before the first frost completely remove the timer and batteries and store inside
MAXIMUM RUNS
1/2-in Poly Tubing - Run up to 300-ft of our 1/2-in Poly Tubing installing up to 50 of our micro spray stake assemblies (MLS-211, MLS-BLA, MLS-TAN) or mister risers (MLS-231) off one faucet
Attach up to 6 of our micro spray kits (MLK-81, MLK-82T, or MLK-LG) off one faucet
Minimum operating pressure for Micro Spray Stake Assemblies: 15 PSI
Maximum operating pressure for Micro Spray Stake Assemblies: 50 PSI
