Part # MLD-.5PC15
.5 GPH Drippers with No Couplers-15 Count
+ -

15 Count Bulk package of 0.5 GPH pressure compensated Drippers (Bulk Pack) with No Couplers included

These 0.5 GPH pressure compensated drippers are used to keep a constant flow of 0.5 GPH at various water pressures up to 25 SI

The water supply enters into the dripper from the red barbed end and then the water is dispersed from the black stem end

Install these drippers directly into the 1/2-in poly tubing by first snapping a hole using either of our punch tools (MLA-51) or (MLA-TOOL) and use our goof plugs (MLA-51G) if you snap a hole in the wrong place or want to relocate the dripper

These drippers can also be installed by running a piece of 1/4-in vinyl tubing to the plant from the 1/2-in poly tubing using the enclosed 1/4-in barbed couplers, then by pushing in the dripper at the other end of the 1/4-in vinyl next to the plant

After the last dripper is installed, turn on the water and allow the flow of water to clean out any debris that may have entered the line during installation

Our 1/4-in support stakes (MLT-DST) can be used to securely hold the 1/4-in vinyl tubing and 0.5 GPH Dripper near the plant

Also, use our 1/4-in tees (MLT-TEE) and elbows (MLT-ELB) to run the 1/4-in vinyl tubing in opposing directions or in tight corners to supply water to these drippers.

(15 Drippers Per Bag)

Drippers made in Australia

Drippers and Drip Tubing should NEVER be buried underground but can be covered lightly with Mulch.


When installing any irrigation system it is important to be aware of manufacturer recommendations and potential system limitations. Please be aware of the follwing:

A 25 PSI Pressure Regulator (MLD-25PR) and a Faucet Filter (MLFF-41) are highly recommended to be used first at the water source when using these 0.5 GPH drippers


1/4-in Vinyl Tubing - Run up to 100-ft of our 1/4-in Vinyl Tubing installing up to 20 of the 0.5 GPH PC Drippers

1/2-in Poly Tubing - Run up to 500- ft of our 1/2-in Poly Tubing installing up to 500 of these 0.5 GPH PC Drippers

Minimum operating pressure for Drippers: 5 PSI

Maximum operating pressure for Drippers: 25 PSI

Product tags
Customers who bought this item also purchased

1/2" Poly Coupling (MLF-36)

1/2-in Poly Coupling with Locking Collars. (QTY 2)

1/2-in Poly Elbow Fitting (MLF-35)

1/2-in Poly Elbow Fitting with locking collars (Qty 1)

Black 13-in Stake w/ clip (MLS-BLST)

Black 13-in Micro-Stake with Clip for 1/4-in Vinyl.

Black Stake Assemb (MLS-BLA)

Black Landscape Stake Assembly with On/Off Valve and 10 GPH Flow-Controller. Each stake sold separately / Mister NOT included.