Search

Adjustable Drip Stakes

$3.89
Adjustable Dripper Stakes with 1/4-in Couplers (Qty 3)
Made in the USA
+ -
Videos

Each dripper stake is adjustable by turning the top dial to water from 0 to 10 GPH and releasing drops of water up to spraying 8 individual streams of water in a 3-ft diameter

When increasing the water output, be sure not to over rotate the top, as it can come off and become lost replacement caps (MLD-STACAP) can be purchased separately

Use these adjustable dripper stakes to gently water patio and potted plants,landscapes or gardens

Install by running a piece of 1/4-in vinyl tubing to the plant from the 1/2-in poly tubing using the enclosed 1/4-in barbed coupler.

Use either of our punch tools (MLA-51 or MLA-TOOL) to snap a hole into the 1/2-in poly tubing to install the 1/4-in barbed coupler that is included in the package.

Push the end of the 1/4-in vinyl onto the side 1/4-in barbed inlet of the stake and place near the base of the plant

If you punch a hole in the wrong place or want to relocate the dripper then simply remove it from the 1/2-in poly and snap in one of our goof plugs (MLA-51G)

Also use our 1/4-in tees (MLT-TEE) and elbows (MLT-ATE) to run the 1/4-in vinyl in opposing directions or in tight corners to supply water to these drippers

(3 Stakes Per Bag)

Drippers and Drip Tubing should NEVER be buried

 

RECOMMENDATIONS & LIMITATIONS

When installing any irrigation system it is important to be aware of manufacturer recommendations and potential system limitations. Please be aware of the following: 

A 25 PSI pressure regulator (MLD-25PR) and a faucet filter (MLFF-41) are highly recommended to be used first at the water source when using these adjustable dripper stakes

 

MAXIMUM RUNS

1/4-in Vinyl Tubing - Run up to 30-ft of our 1/4-in Vinyl Tubing installing no more than eight 8 Adjustable Dripper Stakes set to drip only, only 3 stakes can be used if set to wide open and maximum clicks using 10 GPH and small circle sprays

1/2-in Poly Tubing - Run up to 300-ft of our 1/2-in Poly Tubing installing up to 30 of the Adjustable Dripper Stakes that are wide open to 10 gph with a small stream spray or run up to 300-ft of our 1/2-in Poly Tubing installing up to 100 of the Adjustable Dripper Stakes with the top open to only use up to 2 gph with water dripping at 25 PSI at the faucet

Minimum operating pressure for Adjustable Drippers: 5 PSI for Dripping

Maximum operating pressure for Adjustable Drippers: 15 PSI for Spraying 8 Streams

 

 

Customers who bought this item also purchased

Green Stake Assemb. (MLS-211)

Green Landscape Stake Assembly with On/Off Valve and 10 GPH Flow-Controller. Each stake sold separately / Mister NOT included.
$3.89

1/2-in Poly Elbow Fitting (MLF-35)

1/2-in Poly Elbow Fitting with locking collars (Qty 1)
$2.09

Black Stake Assemb (MLS-BLA)

Black Landscape Stake Assembly with On/Off Valve and 10 GPH Flow-Controller. Each stake sold separately / Mister NOT included.
$3.89

1/2" Poly Support Stk. (MLA-57)

Support Stakes for holding 1/2-in Poly Tubing and 1/2-in In-Line Drip Tubing. (Qty 3)
$2.60