Each Micro-Spray Pot Stake is adjustable by turning the top On/Off Control Valve (MLT-BVA) to water from 0 to 8 GPH by releasing drops of water or up to a 2-ft radius half-circle downward fan spray pattern.
Use these Micro-Spray Pot Stakes to gently water hanging baskets and potted plants.
Install by running a piece of 1/4-in Vinyl Tubing to the plant from the 1/2-inch Poly Tubing using a 1/4-in Vinyl Barb X Barb Coupler (MLT-BXB).
Use either of our punch tools (MLA-51 or MLA-TOOL) to snap a hole into the 1/2-inch Poly Tubing to install the 1/4-in Vinyl Barb X Barb Coupler.
Push the end of the 1/4-inch Vinyl Tubing onto the top of the 1/4-inch barbed inlet of the stake and by using the built-in depth and direction arrow, place the stake near the base of the plant.
Also, use our 1/4-in Tees (MLT-TEE) and 1/4-in Elbows (MLT-ATE) to run the 1/4-in Vinyl Tubing in opposing directions or in tight corners to supply water to these Micro-Spray Pot Stakes.
RECOMMENDATIONS & LIMITATIONS
When installing any irrigation system, it is important to be aware of manufacturer recommendations and potential system limitations. Please be aware of the following:
A 40 PSI pressure regulator (MLA-40PR) and a faucet filter (MLFF-41) are highly recommended to be used first at the water source when using these micro spray pot stakes.
MAXIMUM RUNS
1/4-in Vinyl Tubing - Run up to 30-ft of our 1/4-in Vinyl Tubing installing up to 8 of the Micro Spray Pot Stakes.
1/2-in Poly Tubing - Run up to 300-ft of our 1/2-in Poly Tubing installing up to 65 of our Micro Spray Pot Stakes off one faucet. The first stakes will use up to 6.3 gph and the furthest away stakes at the end of the runs will use approx. 4 gph.
Minimum operating pressure for Micro Stake Assemblies: 5 PSI
Maximum operating pressure for Micro Stake Assemblies: 25 PSI