This complete kit comes with 30-ft of vinyl ( MLT-B30 ), a backflow prevention valve ( MLF-31), a 1/4-in faucet adapter ( MLA-FAS ), and 8 Adjustable Dripper Stakes-older version- (MLD-STA-OLD) to attach to any outdoor faucet to drip water into 8 potted plants or spray water for only 3 plants
Each dripper stake is adjustable by turning the top dial to water from 0 to 10 GPH and releasing drops of water up to spraying 8 individual streams of water in a 2.5-ft diameter
Use the 1/4-in vinyl tee fittings ( MLT-TEE ) to run the vinyl to the adjustable dripper stakes ( MLD-STA) and push the 1/4-in vinyl end onto the 1/4-in barb inlet on the side of the stake
Use the 10 nail fastener clamps ( MLT-VCL ) to secure 1/4-in vinyl to wooden decks and beams to run up to hanging baskets
If you later decide to use our ½-in Poly as the main line, use the removable 1/4-in couplers from the side of the Stake to run lines of the 1/4-in vinyl from the 1/2-in poly tubing
Drippers and Drip Tubing should NEVER be buried underground but can be covered lightly with Mulch
MAXIMUM RUNS
Main line of 1/4-in Vinyl Tubing - Run up to 30-ft of our 1/4-in Vinyl Tubing, installing no more than eight 8 Adjustable Dripper Stakes set to drip only. Only 3 stakes can be used if set to wide open and maximum clicks until the Top Cap stops, using 10 to 13 GPH, and giving a small circle 8 stream spray
Main line of 1/2-in Poly Tubing - Run up to 300-ft of our 1/2-in Poly Tubing, installing up to 30 of the Adjustable Dripper Stakes that are wide open to 10 gph with a small 8 stream spray, or run up to 300-ft of our 1/2-in Poly Tubing, installing up to 100 of the Adjustable Dripper Stakes with the top slightly open to only use up to 2 gph with water dripping at 25 PSI at the faucet
Minimum operating pressure for Adjustable Drippers: 5 PSI for Dripping
Maximum operating pressure for Adjustable Drippers: 50 PSI for Spraying 8 Streams
